Isolation of Loco KAVACH

18 Oct 2026
📖 Viewed 58 times

LOCO KAVACH ISOLATION THROUGH MCB

Important Notice for Loco Pilots

Subject: Isolation of Onboard Loco Kavach

Isolation of onboard Loco Kavach when required by authorised instructions.

All Loco Pilots are advised to familiarise themselves with the location of the Kavach isolation MCB provided inside the machine room on the Cab-1 Loco Pilot (LP) side of the locomotive.

As per the instructions applicable to the relevant section, isolation of onboard Loco Kavach may be required in areas where Kavach operation is not permitted or when isolation is specifically instructed by the competent railway authority for installation, testing, commissioning, equipment-related or other authorised operational reasons.

Location of Kavach Isolation MCB

The Kavach MCB is generally located inside the machine room on the Cab-1 LP side, as shown in the instructional videos below.

Identification: Identify the correct Kavach-associated MCB in the designated enclosure before carrying out any authorised isolation.
Kavach MCB inside machine room on Cab-1 LP side Kavach MCB in a box unit

Kavach MCB inside machine room on Cab-1 LP side Kavach MCB and bypass selector switch
Instructions for Loco Pilots
1. Identify the Correct MCB

Before carrying out any instructed isolation, identify the MCB associated with the Kavach equipment in the designated enclosure.

2. Follow Authorised Instructions

Operate the isolation MCB only when required by applicable railway instructions or directions of the competent authority.

3. Observe the Prescribed Procedure

Follow the approved locomotive-specific Kavach isolation procedure, including any required reporting, recording and operational precautions.

4. Do Not Confuse the Controls

The MCB and rotary bypass selector switch are separate controls. Do not assume that operating the bypass switch is equivalent to electrical isolation.

5. Restoration of Kavach

Restore Kavach only as permitted under the applicable instructions and prescribed procedure.

Kavach Isolation – Instructional Videos
Reference videos for different locomotive types and Kavach equipment configurations
Important: Video demonstrations are for familiarisation only. Always follow the applicable official instructions and locomotive-specific procedure.
Type 1 : Kavach Isolation - MEDHA

Location and identification of the isolation MCB.

Type 2 : Kavach Isolation - HBL

Location and identification of the isolation MCB.

Important Operational Reminder

For sections where Kavach isolation has been instructed during installation and testing activities, such as the HWH–JSG section referred to in the relevant railway communication, Loco Pilots must comply with the applicable instructions for the relevant section and period of operation.

Safety is paramount. Do not independently isolate or bypass Kavach without the required authority or instructions. In case of doubt regarding the correct MCB, isolation procedure or restoration, contact the concerned competent railway official.
Disclaimer: This notice is intended for crew awareness and reference. It does not replace official railway circulars, safety instructions or the approved operating manual applicable to the locomotive and Kavach equipment.