BCT, BFT, BPT- Revised procedure as 13-11-2026

13 Nov 2026
๐Ÿ“– Viewed 172 times

Loco Pilot / ALP / TMR ยท Air Brake Trains

Brake Tests: BCT ยท BFT ยท BPT

Brake Continuity, Brake Feel & Brake Power Tests

Important: These are three separate tests with separate purposes. One test is not a substitute for another.

Follow the procedure

Ensure proper braking. Run safely.

BCT โ€” Brake Continuity Test

Ensure BP and FP continuity and the required pressure throughout the train.

Purpose

Ensure the Crew and Train Manager (TMR) are satisfied that the requisite Brake Pipe (BP) and Feed Pipe (FP) pressures are available throughout the train.

RDSO Procedure

RDSO circulated the procedure for Brake Continuity Test on air-brake coaching trains vide letter No. MS/APB dated 18.04.2006.

When Mandatory

  1. Before starting the train from the originating station.
  2. When an additional locomotive is attached to the front of the train.
  3. When one or more coaches/wagons are attached at any position of the train.
  4. When one or more coaches/wagons are detached from any position other than the extreme rear.
  5. After attending a brake defect by closing an Angle Cock or detaching a BP/FP hose of any coach/wagon or locomotive, if continuity was affected.
  6. After operation of ACP, FSDS & FIBA.

BFT โ€” Brake Feel Test

Feel the brakes working while the train is moving.
  1. Immediately after starting at the station where the crew have taken over charge.
  2. At about 15 kmph, drop BP by 0.5 kg/cm2 through A-9 and release.
  3. Crew should feel the application of brakes; speed should drop to about 10 kmph.

15 โ†’ 10 kmph ยท 0.5 kg/cm2 ยท A-9

ALP Duties During BFT/BPT

  1. Keep a watch and ensure both tests are done by the LP; remind the LP if required.
  2. Equally participate (carefully watch) in BFT & BPT to assess the effectiveness of the braking system.
  3. Note in diary: location, pressure dropped, number of masts A-9 applied, and speed at start and end.

Other Instructions

  1. Give special emphasis at locations where traction change takes place.
  2. Crew should be counselled on the correct use of regenerating braking, rheostat braking, or dynamic braking in diesel loco while conducting Brake Feel and Brake Power Tests. In case of EP brake in EMU/MEMU trains, crew should be counselled on the use of EP brake.

BPT โ€” Brake Power Test

Assess brake effectiveness and braking capability of the train.
  1. In the first Block Section or on the first opportunity (SR 4.32/1(g)).
  2. Speed: Coaching Train 60โ€“70 kmph; Goods Train 40โ€“50 kmph.
  3. Drop BP via A-9, then release after a pause. Coaching & Loaded Goods: 1 kg/cm2; Empty Goods: 0.5 kg/cm2.
  4. By the time BP returns to 5.0 kg/cm2: Coaching 30โ€“35 kmph; Goods 20โ€“25 kmph.
  5. The LP shall observe the effectiveness of brakes and brake power of the train.
  6. As the Air Flow Indicator (AFI) needle comes to โ€˜0โ€™, normal traction may be resumed.
Train Test Speed BP Drop Speed at 5.0
Coaching 60โ€“70 kmph 1 kg/cm2 30โ€“35 kmph
Loaded Goods 40โ€“50 kmph 1 kg/cm2 20โ€“25 kmph
Empty Goods 40โ€“50 kmph 0.5 kg/cm2 20โ€“25 kmph

TMR Duties During BFT/BPT

  1. TMR must watch the speed of the train during the Brake Feel and Brake Power Tests.
  2. If required, TMR shall ask the Loco Pilot to conduct the above tests.
  3. TMR shall also make an entry in the T-34HF about conducting the tests.
  4. If required, TMR shall assist the Loco Pilot by using the brake van valve and hand brake.

This is not a substitute for official railway instructions or currently applicable rules.

Notes & Precautions

  1. Crew shall ensure observation of the signal aspects while performing BFT and BPT.
  2. If there is an up gradient in the first Block Section, suitable guidelines will be issued by the division as per site condition to avoid stalling.

Other Instructions

  1. Give special emphasis at locations where traction change takes place.
  2. Crew should be counselled on the correct use of regenerating braking, rheostat braking, or dynamic braking in diesel loco while conducting Brake Feel and Brake Power Tests. In case of EP brake in EMU/MEMU trains, crew should be counselled on the use of EP brake.